AirTractor 802A on Wipline 1000 floats |
Left wing bay just outboard of the tie down |
20" aft of the leading edge at 25% chord |
Contacts closed at all but flaps up |
Glasair II |
upper port 25 1/4" and lower port 27 1/4" inboard of the outboard wing rib |
Just aft of the main spar 13.25" aft of the leading edge |
During flap extension closed prior to 1/3 flaps |
Glastar |
Just inboard of the most outboard wing rib |
Just aft of the main spar 11 inches aft of the leading edge. |
During flap extension closed prior to 1/3 flaps |
Lake LA4-200 |
Just inboard of the most outboard wing rib |
6" aft of the leading edge (15% chord). |
Closed when flaps not up |
Lancair Legacy |
Ports are pre-installed |
Ports are pre-installed |
During flap extension closed prior to 1/3 flaps |
Lancair 235/320/360 |
Upper port 2" inboard of the most outboard wing rib. Lower port just inboard of the most outboard rib. |
"D" section just forward of the electrical conduit. 3 1/4" aft of the leading edge(12% chord). |
During flap extension closed prior to 1/3 flaps |
Lancair ES |
Upper port 3" inboard of BL202.5 rib inboard face. Lower port 1.5" inboard of BL202.5 inboard face. |
9" aft of the leading edge along the cord line right wing. |
During flap extension closed prior to 1/3 flaps |
Lancair IV with winglets |
Inboard winglet right wing |
7.5" aft of the leading edge |
During flap extension closed prior to 1/3 flaps |
Lancair VI w/o winglets |
Pitot tube dry bay opposite wing |
15 to 40% chord |
During flap extension closed prior to 1/3 flaps |
Murphy Moose |
Middle of the outboard wing bay. Upper port 6" and lower port 4" inboard of the wing skin outer end. |
2 1/2" forward of the wing skin break at the spar |
During flap extension closed prior to 1/3 flaps |
RV-4, RV-6, RV-7,RV-8 |
Middle of the outboard wing bay. Upper port 4 3/4" and lower port 7 1/2" inboard of the wing skin outer end. |
6" forward of the wing skin break at the spar about 12" aft of the leading edge |
During flap extension closed prior to 1/3 flaps |
RV-9 |
Middle of the outboard wing bay. Upper port 4 3/4" and lower port 7 1/2" inboard of the wing skin outer end. |
11" aft of the leading edge measured along the chord line |
During flap extension closed prior to 1/3 flaps |
RV-10 |
Middle of the outboard wing bay. Upper port 9 1/4" and lower port 7 1/4" inboard of the wing skin outer end. |
9" forward of the wing skin break at the spar |
During flap extension closed prior to 1/3 flaps |